DESCRIPTION
The UH-V is a fluorocarbon polypack pre-loaded with a Fluorocarbon o-ring or quad-ring giving positive lip contact at low pressure and vacuum conditions. This seal provides positive lip sealing at all pressures, and stability to the lips resisting collapse under severe load changes and high cycle rates.
The shell is molded in fluorocarbon, ensuring flexibility for installation and high/low temperature performance.
The UH-V seals are available in 4 styles:
Standard (straight lip – the height and cross-section are the same)
Standard B-Lip (beveled lip – the height and cross-section are the same)
Deep (straight lip – the height is greater than the cross-section)
Deep B-Lip (beveled lip – the height is greater than the cross-section)
Most sizes are available with either a straight lip or beveled lip. Beveled lip is denoted with a B at the end of the part number. See Part Number Definition below.
SEAL INFORMATION
Material Type (Primary Seal): FLUOROCARBON
Material Type (Energizer): 70A FLUOROCARBON
Durometer (Shore A): 90
Temperature Range (F): -5 TO 400
Max Pressure (psi): 2250
Extrusion Gap at Various Pressures (in):
- 1,500 PSI: 0.020
- 2,250 PSI: 0.015
Max Speed (ft/sec): 1.6
Mating Surface Roughness - Ra (µin) - DYNAMIC: 4<>16
Mating Surface Roughness - Ra (µin) - STATIC: 32 MAX
Part Number Definition (Inch): UH-(CS)(ID)(HT)-V (OR B-V IF BEVELED LIP)
Additional Part Number Definition (Inch): 2 X 2-1/2 X 3/8 = UH-25002000375-V (OR UH-25002000375B-V)
NOTE: IF A STANDARD OR STANDARD B-LIP SEAL IS REQUIRED, THE HT (HEIGHT) IS OMITTED FROM THE PART NUMBER.